Bresle Test Kit

The company provides Bresle Test Kit that is also known as chloride test kit or salt test kit. We make Bresle Test Kit available for the evaluation of chlorides or/and soluble salt test on blasted steel surface before painting. Our range of Bresle Test Kit is available with bresle test patches, syringes, distilled water, calibration solution and conductivity meter to test for soluble salt as well as surface contaminants on blasted surfaces in compliance with ISO 8502-6 & ISO 8502-9.

Applications

• Oil & gas
• Marine vessels
• Offshore
• pipe coating
• Steel structures

Features

• Highly economical cost and easy
• Attached to the surface
• Distilled water is injected with a syringe into the bresle patch and then extracted
• This is repeated ten cycles of injecting and extracting the liquid in the bresle patch
• This liquid is then measured with the conductivity meter will measure the quantity of salts in both µg/cm2 (ppm) and mg/m2.
• User manual gives easy conversions

Complies With

• ISO 8502-6
• ISO 8502-9
• ISO 8502-6
• ISO 8502-9

Available Packaging

• 50 × Bresle Patches, Conductivity Meter, and Calibration Solution
• 3 × 5ml Syringes, 25ml Beaker and 250ml distilled water in soft carrying case

Part Numbers

• BTK-001 Bresle Test Kit
• BTK-002 Bresle Patch (Pack of 50)