EnglishFrenchHindiPortugueseSpanish

Multi Voltage Pinhole Detector


Multi Voltage Pinhole Detector

The Multi-Voltage Pinhole Detector uses the wet sponge principle to detect through pinholes, cracks and damaged areas in coatings. Operation is by the application of a wet sponge to the coating. The water will be used as wetting agent penetrates any pinhole and makes a conductive path through to the substrate, the PD990 automatically detects this conductive path and sounds an audible alarm and also gives a visual warning by a flashing red indicator that a pinhole fault has been detected. The flaw can now be marked for repair and further testing resumed. The PD990 has selectable test low voltages of 9 Volt / 67.5 Volt and 90 Volt which comply with ASTM specifications. Generally 9V will test up to 300 micron and 90 Volt will test up to 500 micron. Pinhole / Porosity Standards ASTM G62-A, ASTM G6, ASTM D 4787, ASTM D-5162, AS3894.2, BS 7793-2, BS EN ISO 8289 A (Wet Sponge Testing), NACE RPO274-98, NACE RP 0188 and AS1580.485.1 describe the use of pinhole detection.

The pinhole detector is supplied ready to use in a carrying case complete with handle / sponge, earth cable and battery fitted.



Available in

PD990Wet Sponge Pinhole Tester 9/67.5 / 90 Volts
NS002Calibration Certificate
SA002Handle for Wet Sponge 300mm
SA009Standard Wand Sponge 170mm x 55mm x 30mm